Intercode Delay - Datalogic Cobalto C05300 Product Reference Manual

Intercode Delay

Intercode Delay
Specifies the delay between labels transmitted to the host for this interface. The selectable
range for this feature is from 0 to 99 seconds. See
detailed programming instructions.
Set Intercode Delay
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
Product Reference Guide
$CKBID
DEFAULT
"Intercode Delay" on page 228
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from the
Alphanumeric characters in
senting your desired character(s). End by scanning the ENTER/
EXIT bar code again.
00 = No Wedge Intercode Delay
Enter/Exit Programming Mode
for more
Appendix D, Keypad
repre-
~
CANCEL
41