4.12 Touch sensor
4.12 Touch sensor
Removing the Touch sensor
The following describes the procedure for removing the touch sensor (See Figure 4-24).
1. Lift up the latch and remove the AV button holder while sliding it in the direction of
the arrow.
2. Peel off the touch sensor.
3. Disconnect the touch sensor cable from the connector on the touch sensor.
Touch sensor cable
Insulator
NOTE: Do not reuse the touch sensor. Be sure to use a new touch sensor.
QOSMIO G50 Maintenance Manual (960-683)
Downloaded from LpManual.com Manuals
AV button holder
Figure 4-24 Removing the touch sensor
4 Replacement Procedures
Latch
Touch sensor
[CONFIDENTIAL]
4-39