Toshiba QOSMIO G50 Maintenance Manual page 335

4.35 LCD unit/FL inverter
Installing the LCD unit/FL Inverter
The following describes the procedure for installing the LCD unit/FL inverter (See Figure 4-
66 to 4-70).
1. Connect the LCD cable to the connector on the LCD unit and stick the glass tape in
place.
2. Set the brake hinges (left and right) to the LCD unit and secure them with the
following screws.
NOTE: When securing the brake hinges, be sure to secure the screws in the order of the
3. Set the LCD unit to the LCD cover and arrange the cables to the guides.
4. Secure the LCD unit with the following screws.
5. Connect the LCD cable and HV cables to the connector on the FL inverter.
CAUTION: Be careful not to connect the HV cable to the wrong connectors of the FL
6. Set the FL inverter to the slot and secure it with the following screw.
•
7. Set the LCD mask while engaging the latches and secure it with the following
screws.
•
•
8. Stick six LCD cushions (up and low) in place.
QOSMIO G50 Maintenance Manual (960-683)
Downloaded from LpManual.com Manuals
• M2.0×4B
S-THIN HEAD screw
number marked on the brake hinges.
• M2.5×6B
FLAT HEAD screw
inverter.
M2.0×4B S-THIN HEAD screw
M2.5×6B FLAT HEAD screw
M2.5×8B FLAT HEAD screw
4 Replacement Procedures
×8
×6
×1
×4
×2
[CONFIDENTIAL] 4-105