4.14 Touch pad/Fingerprint sensor board/LED board
3. Disconnect the touch pad cable from the connector on the Fingerprint sensor
board/LED board.
4. Remove the following screws and Fingerprint sensor board/LED board from the
slot.
•
Figure 4-27 Removing the touch pad/Fingerprint sensor board/LED board (2)
QOSMIO G50 Maintenance Manual (960-683)
Downloaded from LpManual.com Manuals
M2.0×4B
BIND screw
M2.0x4B BIND
4 Replacement Procedures
×2
Fingerprint sensor board/
LED board
Guide
Touch pad cable
[CONFIDENTIAL]
4-43