KVH Industries TracPhone FB250 Installation Manual page 95

Chapter 6: Service and repair
Mounting the ATB/LNA module
To mount the new ATB/LNA module, repeat the above procedure in reverse:
1. Fit the threaded studs on the antenna into the holes in the sides of the
ATB/LNA module, and fasten the finger screws with torque 1.2 Nm.
2. Reconnect the plugs. Make sure the plugs are connected to the right
connectors on the antenna, and that they are fitted properly. You should
hear a click when the plug is fully inserted.
The cable from the right part of the antenna panel goes to the connector
marked A and the cable from the left part of the antenna panel goes to the
connector marked B in the below drawing. When those two plugs are
inserted, it is easier to see where the remaining plugs belong.
3. Gently lift the cable holder and fit the cables in the holder.
82 Replacing modules
A
B