Chapter 2: Installing the system
hole location. Ensure the baseplate's "Forward" arrow (shown below)
points toward the bow. Set the antenna baseplate aside.
4. Drill the four 1/2" (13 mm) bolt holes and cut out the cable access hole
(following the layout in Step 2). Smooth the edges of the cable access hole
to protect the cable.
5. Clean and dry the antenna mounting surface.
6. Peel off the paper backing from the supplied
foam seal to expose the adhesive. Then press the
foam seal down firmly onto the mounting
surface, ensuring the hole in the foam seal aligns
with the cable access hole in the mounting
surface.
30
Installing the antenna