KVH Industries TracPhone FB250 Installation Manual page 45

Chapter 2: Installing the system
11. Place the radome onto the baseplate. Secure in place with the six #10-32
screws you removed earlier.
12. Install a protective plastic screw cap over all six radome screws.
13. For details on grounding the antenna, see Antenna grounding on page 22.
Mounting the FB500 35" (89 cm) antenna
Do as follows:
1. Remove the eight #10-32 Phillips screws securing the radome to the
baseplate. Carefully lift the radome straight up until clear of the antenna
assembly and set it aside in a safe place.
2. Using the supplied mounting template or the dimensions shown below,
mark the locations for the four antenna mounting bolt holes and cable
access hole at the mounting site.
3. Before drilling the holes in the deck or mounting platform, you need to
verify that the antenna will be aligned properly when it is mounted.
Position the antenna baseplate assembly in place over the mounting hole
locations, with the center hole in the baseplate centered over the cable
32 Installing the antenna