KVH Industries TracPhone FB250 Installation Manual page 44

7. Bring the antenna cable from belowdecks up through the cable access
hole. Connect the antenna cable to the antenna's N-type connector.
8. Place the antenna baseplate over the holes drilled in the mounting
surface, ensuring the baseplate's "Forward" arrow is pointing toward the
bow.
9. At each of the four baseplate mounting holes, place a 3/8" flat washer on a
3/8"-16 bolt and insert the bolt from above, as shown in the diagram.
10. Secure each bolt to the mounting surface using a 3/8" flat washer and a
3/8"-16 lock nut from below. Tighten all four bolts until the four rubber feet
are bottomed against the mounting surface and the foam seal is fully
compressed.
Chapter 2: Installing the system
Installing the antenna 31