KVH Industries TracPhone FB250 Installation Manual page 154

Attaching a TNC or N Connector to
RG214 Cable
These instructions explain how to terminate an RG214 RF cable with a TNC or
N-type connector.
Refer to the following diagram while performing the steps in this procedure.
Do as follows:
1. Be sure all of the connector parts listed below and shown on the following
page are provided in the connector kit:
A Connector Body
B Rubber Gasket
C Clamp
D Nut
E Wide Insulator
Appendix D
F Washer
G Inner Contact
H Narrow Insulator
I Bushing
D
141