11. Place the antenna baseplate over the holes drilled in the mounting
surface, ensuring the antenna's "Forward" arrow is pointing toward the
bow.
12. At each of the four baseplate mounting holes, place an M10 flat washer on
an M10 bolt and insert the bolt into the hole from below, as shown in the
diagram. Tighten all four bolts until the four rubber feet on the baseplate
are bottomed against the mounting surface and the foam seal is fully
compressed.
13. Reinstall the service hatch with the eleven M4 screws you removed earlier.
14. Place the radome onto the baseplate. Secure in place with the eight #10-
32 screws you removed earlier.
15. Install a protective screw cap over all eight radome screws.
16. For details on grounding the antenna, see Antenna grounding on page 22.
Chapter 2: Installing the system
Installing the antenna
35