KVH Industries TracPhone FB250 Installation Manual page 93

Chapter 6: Service and repair
6.2.4 Antenna Tracking Board/Low Noise Amplifier
(ATB/LNA)
Removing the ATB/LNA module
To remove the ATB/LNA module from the antenna, do as follows:
1. Disconnect the six plugs indicated in the drawing below.
Important notes:
• Remember the exact position of each plug, so you do not connect to
the wrong connector when installing the new module.
• Remember to release connector latches on the plugs before pulling
them out.
• Do not pull the wires - pull the plugs.
80 Replacing modules