Mounting the FB500 26" (66 cm) antenna
Do as follows:
1. Remove the six #10-32 Phillips screws securing the radome to the
baseplate. Carefully lift the radome straight up until clear of the antenna
assembly and set it aside in a safe place.
2. Using the supplied mounting template or the dimensions shown below,
mark the locations for the four antenna mounting bolt holes and cable
access hole at the mounting site.
3. Before drilling the holes in the deck or mounting platform, you need to
verify that the antenna will be aligned properly when it is mounted.
Position the antenna baseplate assembly in place over the mounting hole
locations, with the baseplate connector centered over the cable access
Chapter 2: Installing the system
Installing the antenna
29