Chapter 4: Hardware interfaces
4.7.3 Pin-out
The figure and table below show the connector outline and pin assignments.
Pin number
1
2
3
4
5
6
7
8
4.7.4 Connecting an IP handset
To connect the IP Handset to the terminal, do as follows:
Connect the cable from the IP cradle to one of the LAN connectors on the
terminal. For information on how to install the IP handset, refer to the user
manual for the handset.
The cable between IP cradle and terminal must be maximum 80 m.
Note
If you insert a switch or similar between the cradle and the terminal,
make sure that it conforms to the industry standard IEEE 802.3 af
(using data pairs).
64
Pin function
TxD+ input
(positive PoE)
TxD-input
(positive PoE)
RxD+ output
(negative PoE)
not connected
not connected
RxD- output
(negative PoE)
not connected
not connected
LAN interface
RJ-45 female connector