Mdc Configuration Example (In Irf Mode) - HP 12500 Configuration Manual

* no decompiling or reverse-engineering shall be allowed.
******************************************************************************
<Device> system-view
# Change the device name to MDCC for easy identification of the MDC.
[Device] sysname MDCC
# Create VLAN-interface 1 and assign an IP address to it.
[MDCC] interface vlan-interface 1
[MDCC-Vlan-interface1] ip address 192.168.3.251 24
# Return to the default MDC.
[MDCC-Vlan-interface1] return
<MDCC> switchback
[Device]
Verifying the configuration
Check whether the MDCs exist and are operating properly.
1.
<Device> display mdc
ID
----------------------------------
1
2
3
4
The output shows that the MDCs have been created and are operating properly.
Log in to MDCA as an administrator of Company A and then view the current configuration of the
2.
MDC.
C:\> telnet 192.168.1.251
******************************************************************************
* Copyright (c) 2010-2012 Hewlett-Packard Development Company, L.P.
* Without the owner's prior written consent,
* no decompiling or reverse-engineering shall be allowed.
******************************************************************************
<MDCA> display current-configuration
...

MDC configuration example (in IRF mode)

Network requirements
As shown in
requirements of three companies: Company A (LAN 1), Company B (LAN 2), and Company C (LAN 3).
The IRF fabric has two members. The master uses the ID 1 and has two interface cards, one in slot 2 and
the other in slot 3. The subordinate member uses the ID 2 and has one interface card in slot 4. Each
interface card provides 48 Ethernet interfaces.
Company A has four departments, and each department has large amounts of traffic and needs a
dedicated link to connect to the Internet gateway to achieve higher transmission speed. Company B and
Company C each need two links to connect to the Internet gateway, one of which for redundancy.
Name
Admin
MDCA
MDCB
MDCC
Figure 59, a service provider wants to use one IRF fabric to satisfy the Internet access
Status
active
active
active
active
207
*
*
*
*