HP 12500 Configuration Manual page 216

Routing switch series
Table of Contents

Advertisement

Company A has many users and requires more disk space than Company B and Company C. Company
B and Company C do not need a large amount of disk space and the default disk space is enough to
satisfy their disk space requirements.
Company C has less employees and less Internet traffic, and needs only a small amount of CPU
resources.
Figure 59 Network diagram
Configuration procedure
Create and configure MDCA for Company A:
1.
# Create MDCA.
<Device> system-view
[Device] mdc MDCA
It will take some time to create MDC...
This MDC was created successfully.
# Authorize MDCA to use the interface card in the master's slot 2.
[Device-mdc-2-MDCA] location chassis 1 slot 2
# Assign interfaces GigabitEthernet 1/2/0/1 through GigabitEthernet 1/2/0/48 to MDCA.
[Device-mdc-2-MDCA] allocate interface GigabitEthernet 1/2/0/1 to GigabitEthernet
1/2/0/48
The configurations of the interfaces will be lost. Continue? [Y/N]:y
# Specify that MDCA use up to 40 percent of the total disk space.
[Device-mdc-2-MDCA] limit-resource disk chassis 1 slot 0 ratio 40
# Start MDCA.
[Device-mdc-2-MDCA] mdc start
It will take some time to start MDC...
This MDC was started successfully.
[Device-mdc-2-MDCA] quit
******************************************************************************
* Copyright (c) 2010-2012 Hewlett-Packard Development Company, L.P.
* Without the owner's prior written consent,
208
*
*

Advertisement

Table of Contents
loading

Table of Contents