Disabling Alarm Traps For Transceiver Modules; Displaying And Maintaining Device Management Configuration - HP 12500 Configuration Manual

Task
Display alarms present on
transceiver modules.
Display the current measured values
of the digital diagnosis parameters
for transceiver modules.

Disabling alarm traps for transceiver modules

If you install a transceiver module that has no vendor name or a vendor name other than HP, the system
repeatedly outputs traps and logs to notify the user to replace the module. To continue to use such a
transceiver module that is manufactured or customized by HP but has no vendor information, you can
disable alarm traps so the system stops outputting alarm traps.
To disable alarm traps for transceiver modules:
Step
1. Enter system view.
2. Disable alarm traps for
transceiver modules.
Displaying and maintaining device management
configuration
Execute display commands in any view and reset commands in user view.
In standalone mode:
Task
Display device alarm information.
Display MPUs' brand information.
Display the system time, date, local time zone, and
daylight saving time.
Display the copyright statement.
Display CPU usage statistics.
Display historical CPU usage statistics in a chart.
Display hardware information.
Command
display transceiver alarm
{ interface [ interface-type
interface-number ] }
display transceiver diagnosis
{ interface [ interface-type
interface-number ] }
Command
system-view
transceiver phony-alarm-disable
Command
display alarm [ slot slot-number ]
display brand
display clock
display copyright
display cpu-usage [ slot slot-number [ cpu cpu-number ] ]
display cpu-usage history [ job job-id ] [ slot slot-number
[ cpu cpu-number ] ]
display device [ cf-card ] [ slot slot-number | verbose ]
194
Remarks
N/A
This command cannot display
information for some transceiver
modules.
Remarks
N/A
By default, alarm traps are
enabled for transceiver modules.