Configuration Procedure; Non-Issu Software Upgrade Example (For Irf Mode); Network Requirements - HP 12500 Configuration Manual

Configuration procedure

# Configure IP addresses and routes to make sure the device and the TFTP server can reach each other.
(Details not shown.)
# Complete TFTP settings on both the device and the TFTP server. (Details not shown.)
# Display information about the current software images.
<Sysname> display version
NOTE:
In the example, the image file is saved to the root directory of Flash memory.
# Use TFTP to download the image file startup-r7122.ipe from the TFTP server to the root directory of
Flash memory on the active MPU.
<Sysname> tftp 2.2.2.2 get startup-r7122.ipe
# (Optional.) Back up the image file to startup-r7122-backup.ipe. Skip this step if the Flash memory does
not have sufficient space.
<Sysname> copy startup-r7122.ipe startup-r7122-backup.ipe
# Specify startup-r7122.ipe as the main startup image file for both MPUs.
<Sysname> boot-loader file flash:/startup-r7122.ipe slot 0 main
<Sysname> boot-loader file flash:/startup-r7122.ipe slot 1 main
# Specify startup-r7122-backup.ipe as the backup startup image file for both MPUs.
<Sysname> boot-loader file flash:/startup-r7122-backup.ipe slot 0 backup
<Sysname> boot-loader file flash:/startup-r7122-backup.ipe slot 1 backup
# Verify the startup image settings.
<Sysname> display boot-loader
# Reboot the device to complete the upgrade.
<Sysname> reboot
# Verify that the device is running the correct software.
<Sysname> display version
Non-ISSU software upgrade example (for IRF
mode)

Network requirements

Use the file startup-r7122.ipe to upgrade software images for the IRF fabric in
Each IRF member device has two MPUs: one in slot 0 and one in slot 1. The global active MPU is in slot
0 on the master device.
109
Figure 38.