HP 12500 Configuration Manual page 218

[Device]
Create and configure MDCC for Company C:
3.
# Create MDCC.
[Device] mdc MDCC
It will take some time to create MDC...
This MDC was created successfully.
# Authorize MDCC to use the interface card in the subordinate member's slot 4.
[Device-mdc-4-MDCC] location chassis 2 slot 4
# Assign interfaces GigabitEthernet 2/4/0/1 through GigabitEthernet 2/4/0/48 to MDCC.
[Device-mdc-4-MDCC] allocate interface GigabitEthernet 2/4/0/1 to GigabitEthernet
2/4/0/48
The configurations of the interfaces will be lost. Continue? [Y/N]:y
# Set the CPU weight of MDCC to 5.
[Device-mdc-4-MDCC] limit-resource cpu weight 5
# Start MDCC.
[Device-mdc-4-MDCC] mdc start
It will take some time to start MDC...
This MDC was started successfully.
[Device-mdc-4-MDCC] quit
# Log in to MDCC from the default MDC.
[Device] switchto mdc MDCC
******************************************************************************
* Copyright (c) 2010-2012 Hewlett-Packard Development Company, L.P.
* Without the owner's prior written consent,
* no decompiling or reverse-engineering shall be allowed.
******************************************************************************
<Device> system-view
# Change the device name to MDCC for easy identification of the MDC.
[Device] sysname MDCC
# Create VLAN-interface 1 and assign an IP address to it.
[MDCC] interface vlan-interface 1
[MDCC-Vlan-interface1] ip address 192.168.3.251 24
# Return to the default MDC.
[MDCC-Vlan-interface1] return
<MDCC> switchback
[Device]
Verifying the configuration
Check whether the MDCs exist and are operating properly.
1.
<Device> display mdc
ID
----------------------------------
1
2
3
Name Status
Admin active
MDCA active
MDCB active
210
*
*
*