HP 12500 Configuration Manual page 217

* no decompiling or reverse-engineering shall be allowed.
******************************************************************************
<Device> system-view
# Change the device name to MDCA for easy identification of the MDC.
[Device] sysname MDCA
# Create VLAN-interface 1 and assign an IP address to it.
[MDCA] interface vlan-interface 1
[MDCA-Vlan-interface1] ip address 192.168.1.251 24
# Return to the default MDC.
[MDCA-Vlan-interface1] return
<MDCA> switchback
[Device]
Create and configure MDCB for Company B:
2.
# Create MDCB.
[Device] mdc MDCB
It will take some time to create MDC...
This MDC was created successfully.
# Authorize MDCB to use the interface card in the master's slot 3.
[Device-mdc-3-MDCB] location chassis 1 slot 3
# Assign interfaces GigabitEthernet 1/3/0/1 through GigabitEthernet 1/3/0/48 to MDCB.
[Device-mdc-3-MDCB] allocate interface GigabitEthernet 1/3/0/1 to GigabitEthernet
1/3/0/48
The configurations of the interfaces will be lost. Continue? [Y/N]:y
# Start MDCB.
[Device-mdc-3-MDCB] mdc start
It will take some time to start MDC...
This MDC was started successfully.
[Device-mdc-3-MDCB] quit
# Log in to MDCB from the default MDC.
[Device] switchto mdc MDCB
******************************************************************************
* Copyright (c) 2010-2012 Hewlett-Packard Development Company, L.P.
* Without the owner's prior written consent,
* no decompiling or reverse-engineering shall be allowed.
******************************************************************************
<Device> system-view
# Change the device name to MDCB for easy identification of the MDC.
[Device] sysname MDCB
# Create VLAN-interface 1 and assign an IP address to it.
[MDCB] interface vlan-interface 1
[MDCB-Vlan-interface1] ip address 192.168.2.251 24
# Return to the default MDC.
[MDCB-Vlan-interface1] return
<MDCB> switchback
209
*
*
*
*