Nortel Server 1005r Maintenance And Diagnostics page 53

June 2007
Result: The system runs the tracert utility.
4 Type Exit to exit the Command Prompt dialog box and return to
Windows.
The arp command
The arp command displays and modifies the IP-to-physical address
translation tables used by Address Resolution Protocol (ARP).
ARP command syntax
The ARP command uses the following syntax:
arp -s inet_addr eth_addr [if_addr]
arp -d inet_addr [if_addr]
arp -a [inet_addr] [-N if_addr]
ARP command parameters
Table 7: ARP command parameters
Parameter
-a
-g
inet_addr
if_addr
eth_addr
1005r Server Maintenance and Diagnostics
Description
Displays current arp entries by interrogating the current
protocol data. If inet_addr is specified, the IP and
physical addresses for the specified computer appear. If
more than one network interface uses arp, entries for
each arp table appear.
Same as -a.
Specifies an Internet address.
Specifies the Internet address of the interface where the
address translation table can be modified. If not present,
the first applicable interface is used.
Specifies a physical address.
Using Windows online diagnostic tools
53