Nortel Server 1005r Maintenance And Diagnostics page 33

June 2007
Error message
A: Drive Error
CMOS Battery Low
CMOS Display Type Wrong
CMOS Checksum Bad
CMOS Settings Wrong
CMOS Date/Time Not Set
DMA Error
FDC Failure
HDC Failure
Checking NVRAM....
1005r Server Maintenance and Diagnostics
Troubleshooting your CallPilot system
Description
No response from the disk drive.
The battery is losing power. Replace
the battery soon.
The display type is different from that
stored in CMOS. Check Setup to make
sure the type is correct
The CMOS checksum is incorrect.
CMOS memory can be corrupted. Run
Setup to reset the values.
The CMOS values are not the same as
the last boot. Either these values are
corrupted or the battery failed.
The time or date values stored in
CMOS are invalid. Run Setup to set the
correct values.
An error occurred during the read/write
test of the DMA (Direct Memory
Access) controller.
An FDC Failure error occurred while
trying to access the diskette drive
controller.
An error occurred trying to access the
hard disk controller.
The NVRAM (Non-Volatile Random
Access Memory) is being checked to
see if it is valid.
33