Replacing basic chassis components
Figure 30: DVD combo drive assembly
6
Slide the DVD combo drive assembly from the chassis.
Note: There are no cables to disconnect.
7
Remove the screw on the left side of the drive assembly and save it
for installing the new DVD combo.
8
Remove the DVD combo drive from the carrier.
a. Open the two latches holding the DVD combo drive in the
b. Disconnect the ribbon cable.
c. Disconnect the power cable from the DVD combo drive.
d. Remove the three screws that fasten the carrier around the
e. Gently pry open the carrier and remove the DVD combo drive.
9
Install the new DVD combo drive in the carrier.
a. Line up the pins on each side of the bracket (two on each side)
130
carrier.
DVD combo drive.
with the holes in the drive and set the replacement DVD combo
drive into the drive bracket. Push gently on one side of the
bracket to push the pins into place.
Standard 1.10
CallPilot