Cleaning And Maintenance - Zanussi ZTH485 User Manual

be activated or deactivated by holding down the EXTRA
DELICATE and INTENSIVE buttons simultaneously for 5
seconds.
The icon appears in the display to indicate that the
child safety device is activated.
Any changes of drying parameters require child lock
deactivation.
The child lock cannot be deactivated in the last phase of
the drying cycle.
Changing programme
To change a programme which is running, first cancel it
by turning the programme selector dial to
new programme and press the START/PAUSE button.
The programme can no longer be changed directly
once the programme has started. If nevertheless
there is an attempt to change the programme on the pro-
gramme knob, the programme progress display and the
maintenance indicators flash. If an option button (exclud-
ing the BUZZER button) is pressed,
display. The drying programme is not however affected by
this (laundry protection).
Drying cycle complete / removing laundry
Once the drying cycle is complete, the display shows the
anti-crease icon and flashing as well as warning

Cleaning and maintenance

Emptying the water reservoir
Empty the water reservoir after every drying cycle.
Caution! The condensed water is not suitable for
drinking or for preparing foodstuffs.
If the programme has been interrupted as a result of
the water reservoir being full: Press the START/
PAUSE button to continue the drying cycle.
lamps: FILTER and FULL TANK . If the BUZZER button has
been pressed, an acoustic signal sounds intermittently for
about one minute.
The drying cycles are automatically followed by an
anti-crease phase which lasts around 30 minutes.
The drum rotates at intervals during this phase. This
keeps the laundry loose and free of creases. The laundry
can be removed at any time during the anti-crease phase.
(The laundry should be taken out towards the end of the
anti-crease phase at the latest to prevent creases from
forming.)
1. Open door.
. Select the
2. Before removing the laundry, remove fluff from the
micro-fine filter. It is best to use a damp hand for this
purpose. (See "Cleaning and maintenance" chapter.)
3. Remove laundry.
4. Turn the programme selector to
5. Close the door.
After each use
appears on the
• Clean the filters.
• Empty the water reservoir.
Cleaning fluff filters
The filters collect all the fluff which accumulates during
drying. To ensure that the dryer works perfectly, the fluff
filters (micro-fine filter and fine strainer) must be cleaned
after every drying cycle.
off.
23