Cleaning And Maintenance - Zanussi ZTH 485 User Manual

audible confirmation of:
• cycle end
• anti-crease phase start and end
• cycle interruption
• error
TIME
after setting the Time programme. You can se-
lect a programme duration from 10 mins to 2 hrs in
10-minute steps.
DELAY START
allows to delay the start of a drying programme
from minimum of 30 min. to maximum of 20 hours.
Press the Delay Start button repeatedly until the
desired delay start is shown on the display
Setting child lock
The child lock can be set to prevent a pro-
gramme being accidentally started or a pro-
gramme in operation being accidentally
changed. The child lock function locks all but-
tons and the programme selector. The child
lock can be activated or deactivated by holding
down the DELICATE and
buttons simultaneously for 5 seconds.
The icon appears in the display to indicate
that the child safety device is activated.
Any changes of drying parameters require
child lock deactivation.
The child lock cannot be deactivated in the last
phase of the drying cycle.
Changing programme
To change a programme which is running, first
cancel it by turning the programme selector dial
to OFF. Select the new programme and
press the START/PAUSE button.

Cleaning and maintenance

Emptying the water reservoir
Empty the water reservoir after every drying cy-
cle.
www.zanussi.com
nevertheless there is an attempt to change the
programme on the programme knob, the pro-
gramme progress display and the maintenance
indicators flash. If an option button (excluding
the
pears on the display. The drying programme is
not however affected by this (laundry protec-
tion).
Drying cycle complete / removing laundry
Once the drying cycle is complete, the display
shows the
well as warning lamps:
If the
acoustic signal sounds intermittently for about
one minute.
around 30 minutes. The drum rotates at inter-
vals during this phase. This keeps the laundry
loose and free of creases. The laundry can be
removed at any time during the anti-crease
phase. (The laundry should be taken out to-
INTENSIVE wards the end of the anti-crease phase at the
latest to prevent creases from forming.)
1. Open door.
2. Before removing the laundry, remove fluff
3. Remove laundry.
4. Turn the programme selector to
5. Close the door.
The programme can no longer be changed
directly once the programme has started. If
BUZZER button) is pressed,
anti-crease icon and flashing as
BUZZER button has been pressed, an
The drying cycles are automatically fol-
lowed by an anti-crease phase which lasts
from the micro-fine filter. It is best to use a
damp hand for this purpose. (See "Clean-
ing and maintenance" chapter.)
ap-
FILTER and TANK .
off.
11