Cleaning And Maintenance - Zanussi ZTK 123 User Manual

At the end of the programme
If the laundry is not removed at the end of the
cycle, the dryer performs an anticreasing phase
(duration: 30 minutes maximum).
If you do not remove the laundry, the dryer will
stop automatically at the end of the anticreas-
ing phase. Lights
Water reservoir remain lit and the buzzer
sounds for 2 minutes.
Turn the programme selector dial to
switch the machine off. Remove the laundry
from the drum and carefully check that the
drum is empty.

Cleaning and maintenance

Cleaning lint filters
To ensure that the appliance works perfectly,
the lint filters in the door and in front of the
drum must be cleaned after every drying cycle.
Caution! Important. Never operate the
dryer without the lint filter or with a
damaged or blocked lint filter.
1. Open loading door 2. After a period of
26
End of programme , and
to
time, a patina due to
detergent residue on
laundry forms on the
filters. Then clean the
filters with warm wa-
ter using a brush. Re-
move the filter from
the door pulling it
out.
If you do not intend to carry out another wash,
close the water tap. Leave the door open to
prevent the formation of mildew and unpleas-
ant smells.
If you open and then close the door be-
fore turning the selector dial to
lights corresponding to the phases making up
the performed programme come on.
After each use
• Clean the filters.
• Empty the water reservoir.
3. Use a damp hand
to clean the micro-
fine filter, which is
built into the lower
part of the loading
aperture.
Cleaning heat exchanger
Clean the condenser when light
comes on.
The condenser is situated at the lower part of
the cabinet behind a small door.
all the
4. Remove fluff from
lint filter, preferably
using a damp hand
for this purpose.
Replace the filter.
Condenser
www.zanussi.com