Troubleshooting - Magic Vac Maxima 2 Operating Manual

In the upper part of the machine there is a convenient Accessory Compartment (15) where you can
keep the Canister Tube (16) (fig. X3) and the Bag Cutter, manual MAGIC Cutter (where applicable)
(fig. X4).
fig. X1
When you are not using the machine, you can place it in a vertical position to reduce space.
Proceed as follows:
a) Insert the Power Cable (17) in the Cable Compartment (18) on the back of the machine (fig. W1).
b) Close the machine by rotating the Handles (1) to the STORAGE position (fig. W2 and W3).
ATTENTION: do not turn the Handles (1) to the START position because complete closure of the
machine when it is inactive for a long period of time could damage the Airtight Seal (7) causing a
leak in the Vacuum Chamber (8) and subsequent failure of the machine to work properly.
c) Place the machine in a vertical position far from heat sources (fig. W4).
fig. W1
18
17
and in the electrical outlet. Check the electrical outlet by trying another device in
MAGIC VAC ® does not
the same outlet.
work
machine.
Check that the piece of cut roll is correctly positioned as described in the
MAGIC VAC ® does not
paragraph: "5 - Making bags from MAGIC VAC
perform the first seal on
the piece of cut roll.
integrity of the Sealing Gasket
MAGIC VAC ® does not
completely vacuum-
Chamber (8). Check the correct position through the Lit WINDOW (3).
pack the bags
ACCESSORY COMPARTMENT
fig. X2
STORING THE MACHINE
fig. W3
fig. W2

TROUBLESHOOTING

39
fig. X4
fig. X3
fig. W4
®
is fully inserted in the machine
®
rolls". Check the position and