Spark Plugs; Battery - Can-Am Outlander X mr Series Operator's Manual

Spark Plugs

Spark Plug Access
Remove side panels.
Unplug spark plug cables.
Spark Plug Removal
CAUTION Always wear safety
goggles when using pressurized air.
Unscrew spark plugs one turn.
Clean spark plugs and cylinder heads
with pressurized air if possible.
Unscrew spark plugs completely then
remove them.
vmo2006-007-029_a
RH SIDE — REAR CYLINDER
1. Spark plug
vmo2006-007-030_a
LH SIDE — FRONT CYLINDER
1. Spark plug
Spark Plug Installation
Prior to installation, make sure that
contact surfaces of cylinder heads and
spark plugs are free of grime.
Using a feeler gauge, set the spark plug
gap.
570
650
850
1000R
Apply a small amount of copper-based
anti-seize lubricant over spark plug
threads.
Screw spark plugs into cylinder heads
by hand and tighten with a torque
wrench and a proper socket.
SPARK PLUG TIGHTENING TORQUE
20 N•m ± 2.4 N•m (15 lbf•ft ± 2 lbf•ft)

Battery

Unless otherwise indicated, al-
ways turn ignition switch to the
OFF position before performing
any maintenance or repair on elec-
trical system.
CAUTION Never charge a bat-
tery while installed in vehicle.
These vehicles are equipped with a
VRLA battery (Valve Regulated Lead
Acid). It is a maintenance-free type
battery, there is no need to add water
to adjust electrolyte level.
NOTICE
sealing cap.
Battery Removal
NOTICE
BLACK (-) battery cable first.
______________
MAINTENANCE PROCEDURES
SPARK PLUG GAP
0.7 mm to 0.8 mm
(.028 in to .031 in)
0.7 mm to 0.9 mm
(.028 in to .035 in)
WARNING
Never remove the battery
Always disconnect
131