Electrical System; Spark Plug Removal/Installation; Battery - Can-Am MAX 400 EFI Operator's Manual

ELECTRICAL SYSTEM

WARNING
Unless otherwise indicated, al-
ways turn ignition switch to the
OFF position before performing
any maintenance or repair on elec-
trical system.
Spark Plug Removal/
Installation
Removal
Remove LH side panel.
Unplug the spark plug cable.
Clean the spark plug and cylinder head
with pressurized air if possible.
WARNING
Always wear safety goggles when
using pressurized air.
Unscrew spark plug completely then
remove it.
vmo2008-019-031_a
1. Spark plug cable
Installation
Prior to installation make sure that
contact surfaces of cylinder head and
spark plug are free of grime.
Using a feeler gauge, set the spark
plug gap between 0.7 to 0.8 mm
(0.028 to 0.032 in).
Apply anti-seize lubricant over spark
plug threads to prevent a possible
seizure.
Screw spark plug into cylinder head by
hand and tighten with a torque wrench
and a proper socket.
Torque
(15 lbf•ft).

Battery

Never charge a battery while in-
stalled in vehicle.
These vehicles are equipped with a
VRLA battery (Valve Regulated Lead
Acid). It is a maintenance-free type
battery, there is no need to add water
to adjust electrolyte level.
CAUTION: Never remove the bat-
tery sealing cap.
Removal
Disconnect BLACK (-) cable first then
RED (+) cable.
Always respect this order for dis-
assembly; disconnect BLACK (-)
cable first.
Remove the holding strap then pull the
battery out of frame.
_____________________
spark plug to
WARNING
WARNING
20 N•m
127