Table of Contents
Advertisement
CHAPTER 2 USING THE MACHINE
ADF Test (6-4: ADF)
Use it to check the operation of the ADF.
Press '4' on the keypad while the FACULTY TEST menu is indicated to select ADF test.
Place an original in the original placement area, and press the Start key so that the original
will be moved at a specific speed.
Select this item, press 10 originals in the ADF, and press '8' on the keypad to execute reg-
istration arch auto adjustment (only if equipped with ADF functions). (See 1.3.4 of Chapter
7.)
Speaker test (6-6: SPEAKER)
Use it to check the operation of the speaker.
Press '6' on the keyboard while the FACULTY TEST menu is indicated to select speaker
test. In the test, tonal signal sounds of between 200 Hz to 5 kHz at 100-Hz intervals are gen-
erated white changing the volume. Check to see if the speaker generates these signals.
2-82
COPYRIGHT © 2001 CANON INC.
Press '5' on the keypad.
BSCT on
BDSS3-0 [of of of of]
Not used.
Press '6' on the keypad.
Panel1
Not used.
Press '7' on the keypad.
NCR Sts : NCR None
Not used.
F02-321-13
6-6: SPEAKER
FREQ:[1]
Press '1' on the keypad.
6-6: SPEAKER
FREQ TEST
Press the Start key
to change the
transmission frequency.
F02-321-14
2000 2000 2000 2000
BDOC[A3 ]
VOL:[2]
Press '2' on keypad.
6-6: SPEAKER
VOL[*] :MIN [#]:MAX
Adjust the volume
of the signals; at *,
min.; at #, max.;
may be changed in
steps by pressing the
Start key.
CANON SmartBase PC1200s/iR1200s REV. 0 DEC. 2001
Advertisement
Table of Contents
Troubleshooting
