Program 710 - Clerk Report Message Programming - Sam4s ER-900 Series Operation And Program Manual

Program 710 - Clerk Report Message Programming

The Clerk Report selection allows you to reprogram the descriptors that appear with the Clerk Report
totals and counters. For example, the first total on the clerk report "NET SALES" might be re-labeled
to say "GROSS SALES". You can reprogram any of the Financial Report totals listed here with any
18-character descriptor. (See "Clerk Report Message").
Programming the Clerk Report Message
1. Turn the control lock to the PGM position.
2. To begin the program, enter 7 1 0, press the SUBTL key.
3. Refer to the chart below and enter the number that represents the line you wish to
program; press the X/TIME key.
4. If you are programming using alpha overlay, type up to 18 descriptors on the overlay
and press the SUBTL key
NOTE: As you are entering descriptors only the last 16 descriptors will display.
If you are programming using descriptor codes, enter up to 18 three-character codes and
press the SUBTL key.
Enter up to 18 three-digit
5. To program additional Clerk Report Message, repeat from step 3, or press the CASH
key to finalise the program.
192 • Program Mode Programming
7 1 0 SUBTL
X X/TIME
Type up to 18
descriptor keys
or,
character codes
CASH
SUBTL
SUBTL
SAM4S ER-900 Series Electronic Cash Register AU