Program 710 - Clerk Report Message Programming - Sam4s ER-390M Operation And Program Manual

Program 710 - Clerk Report Message Programming

Program descriptions by typing description on the alpha keyboard overlay or by entering three digit
alpha character codes. To use three digit alpha character codes you must select 'No' in system
option #30 (See "System Option Programming). Also see Descriptor Programming Methods for
Alpha Overlay and/or Descriptor Code Table.
Programming the Clerk Report Message
The Clerk Report selection allows you to reprogram the descriptors that appear with the Clerk
Report totals and counters. For example, the first total on the clerk report "NET SALES"
might be re-labeled to say "GROSS SALES". You can reprogram any of the Financial Report
totals listed here with any 18-character descriptor. (See "Clerk Report Message").
1. Turn the control lock to the PGM-Mode.
2. To begin the program, enter 7 1 0, press the SBTL key.
3. Refer to the chart below and enter the number that represents the line you wish to
program; press the X/TIME key.
4. If you are programming using alpha overlay,
three-character codes
5. Press the CASH key to finalize the program.
ER-390M Electronic Cash Register AU
7 1 0 SBTL
X X/T IME
Type up to 18
descriptor keys
or,
Enter up to 18
CASH
SBTL
SBTL
Program Mode Programming •159