Program 710 - Clerk Report Descriptor Programming - Sam4s ER-920 Operator's And Programming Manual

Program 710 - Clerk Report Descriptor Programming

The Clerk Report selection allows you to reprogram the descriptors that appear with the Clerk
Report totals and counters. For example, the first total on the clerk report "NET SALES"
might be re-labeled to say "GROSS SALES". You can reprogram any of the Clerk Report
totals listed here with any 18-character descriptor.
192 • P-Mode Programming
1. Turn the control lock to the PGM position.
2. To begin the program, enter 7 1 0, press the SUBTL key.
7 1 0
3. Refer to the chart on the next page and enter the number that represents the line
you wish to program; press the X/TIME key.
X X/TIME
X
4. If you are programming using an alpha keyboard overlay, type up to 18
descriptors on the overlay and press the SUBTL key. (Note: As you are entering
descriptors only the last 16 descriptors will display.)
Type up to 18
descriptor keys
If you are programming using descriptor codes, enter up to 18 three-character
codes and press the SUBTL key.
Enter up to 18 three-
character codes
5. Press the CASH key to finalize the program.
CASH
SUBTL
SUBTL
SUBTL
SAM4s ER-900 Series Operator's & Programming Manual v.1.3