Er-925/945 Memory All Clear (Ram All Clear) - Sam4s ER-900 Series Operation And Program Manual

ER-925/945 Memory All Clear (RAM All Clear)

To Perform a Memory All Clear (reset memory completely)
1. Turn the power switch located on the right side of the register to the OFF position.
2. Turn the control lock to the S position (one passed PGM position as a hidden position).
3. Press and hold the button position where the SUBTOTAL (SUBTL) button (circled
button) is located on the default keyboard layout.
4. Continue to hold the SUBTOTAL (SUBTL) button while turning the power switch to
the ON position.
5. After the BEEP, release the SUBTOTAL (SUBTL) button, RAM ALL CLEAR will
appear on the display.
6. Press the upper left button (PLU #1) of the keyboard, then the lower left button (PLU
#10), then the upper right button (CLERK), and finally press the lower right button
(CASH). After each button press, a
1
2
3 10
4 11
5 12
6 13
7 14
7. After a while, Please Wait... appears on the display along with those 4
memory is cleared, the register prints a message "RAM ALL CLEAR OK!". This is
then followed by firmware info.
8. The display then shows PRINTER 2STATION Y=CASH N=CLEAR. For an ER-920
(one printer station), press CLEAR; for an ER-940 (two printer stations), press CASH.
96 • Service Mode Programming
8 15 22 29
9 16 23 30
17 24 31
18 25 32
19 26 33
20 27 34
21 28 35
91 Key Keyboard Shown Above
symbol appears on the lower line of display.
36 43 50
37 44 51
38 45 52
39 46 53
40 47 54
41 48 55
42 49 56
SAM4S ER-900 Series Electronic Cash Register AU
RECEIPT
JOURNAL
# / NS
FEED
FEED*
ERROR
RETURN CANCEL VOID
CORR
CLEAR X/TIME
PLU
7 8 9
CHECK
4 5 6
1 2 3
0 00
s. When
PLU CLERK
RA
% 1 PO
CHARGE
1
SUBTL
CASH
TEND