By Cursor Key; Deleting A Route; Other Settings In Route Menu - Standard Horizon CP500 Owner's Manual

5. Move the ShuttlePoint knob to the highlight the desired Route and press [ENT].
6. On the Chart page, a circle with a Flag is shown on the first leg of the Route you chose
and a navigation line is shown, indicating the GPS Chart Plotter is navigating to the first
Waypoint in the Route.
9.6.1

By Cursor key

1. On the Chart page move the ShuttlePoint knob until the cursor reaches the starting point
of the Route.
2. Press [GOTO] to start following the Route.
3. Press [CLR] twice to revert to Home mode.
9.7

DELETING A ROUTE

To delete a Route follow the procedure below:
1. Press [MENU]. Move the ShuttlePoint knob to highlight USER POINTS and press
[ENT].
2. Move the ShuttlePoint knob to highlight ROUTE and press [ENT].
3. Move the ShuttlePoint knob to highlight DELETE and press [ENT] or move the
ShuttlePoint knob to the right.
4. A Warning message appears to confirm. Move the ShuttlePoint knob to highlight YES
and press [ENT]. The Route has been deleted.
An active Route (one that you are navigating to) cannot be deleted until you stop navigating to the
Route.
9.8

OTHER SETTINGS IN ROUTE MENU

You will notice the ROUTE menu has other selections.
SELECT Choose an available Route to create or choose a stored Route to show and follow on the Chart page.
REVERSE Reverses the Route, when chosen Starting point is at the end of the Route.
COLOR Allows changing the color of the navigation lines between each leg in the Route.
REPORT The Route Report menu is useful to show details of the Waypoints contained within the Route. This menu
also allows you to enter in your average speed and fuel consumption and calculate the approximate fuel
used when following the Route.
SEND Sends the stored points to a external device (PC) capable of listening to NMEA RTE sentence.
RECEIVE Receive the points from an external device (PC) capable of sending NMEA RTE sentence.
THICKNESS Selection that allows the Route line to be easily seen; default selection is Thick.
CP500
Figure 9.6.0a - GOTO ROUTE procedure (2)
WARNING
Page 67
R