Navigating A Route In Simulation Mode; Dsc Polling - Standard Horizon CP500 Owner's Manual

13.4.0 Navigating a Route in Simulation mode

This selection allows you to navigate to a saved Route to see how data windows on the Chart
page and how the Navigation and Highway pages operate.
1. Create a Route. Refer to Par. 9.0 Route.
2. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press
[ENT].
3. Move the ShuttlePoint knob down to highlight ADVANCED SETUP, then press [ENT].
4. Move the ShuttlePoint knob to highlight SIMULATION and press [ENT].
5. Move the ShuttlePoint knob to highlight SIMULATION MODE and press [ENT] to show
a popup window.
6. Move the ShuttlePoint knob to highlight ROUTE and press [ENT] which will show a
popup window with the Route(s) that are stored in the GPS Chart Plotter's memory.
7. Highlight the desired Route and press [ENT].
8. Move the ShuttlePoint knob to highlight SPEED and press [ENT].
9. Enter in the speed you want to vessel to travel at in simulation mode, by moving the
ShuttlePoint knob left or right to select a number and up or down to change a number.
10. When the speed is adjusted, press [ENT].
11. Press [CLR] multiple times until the Chart page is shown.
13.5

DSC POLLING

This menu is used to enable or disable features related to the DSC function.
Auto Position : Selects between Manual or Auto. See also the Par. 12.8.1. When Auto Position item is set to
Manual and receiving the Position Request, the Position Request pop-up window is not displayed
and the cursor does not move to the position of the received Position Request data point.
Otherwise when Auto Position item is set to Auto, the GPS chart plotter works as follows:
Auto Info : Enables or disables the Auto Info. This selection is available only when Auto Position is set to
Manual. If Auto Info is set to On, when receiving the Position Request it is possible to center the
cursor over the top of the Position Request icon and show the Position Request popup window
Page 96
1 : when receiving the Position Request, the Position Request popup window is displayed;
2 : when selecting VIEW ON CHART, the position is indicated on the chart marked with "P".
The cursor is moved to the point "P" and shows the point in the center of the screen;
3 : when moving the cursor from "P", the location can be confirmed. At this time, the same
MMSI Position Request data that were received before are remaining and displayed.
CP500
R