Icons Size; Place Names Size - Standard Horizon CP500 Owner's Manual

Note that in the top of the previous picture the chart scale remains the same but it is
graphically compressed.
By pressing [ZOOM IN]/[ZOOM OUT] a popup window is displayed on a corner of the chart
screen. The window shows the current zoom factor: Normal is the original chart level (1:1
scale), Over-Zoom x2, x4, x16, x32, Under-Zoom x1/2, x1/4.
To activate this function follow the procedure:
1. Press [MENU]. Move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight MAX FUNCTIONS and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight ZOOM TYPE and press [ENT] or move the
ShuttlePoint knob to the right.
4. The menu now shows two selections, STANDARD or FLEXI-ZOOM.
5. Move the ShuttlePoint knob to select the selection and press [ENT].
6. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left a few times.
6.0.1

Icons Size

On MAX charts it is possible to set the size of all icons drawn on the charts, selecting
between Standard and Large size.
ICONS SIZE standard
To activate this function follow the procedure:
1. Press [MENU]. Move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight MAX FUNCTIONS and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight ICONS SIZE and press [ENT] or move the
ShuttlePoint knob to the right.
4. The menu now shows two selections, STANDARD or LARGE.
5. Move the ShuttlePoint knob to select the selection and press [ENT].
6. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left a few times.
6.0.2

Place Names Size

On MAX charts it is possible to set the size of all names drawn on the charts, selecting
between Standard, Medium and Large size.
Page 46
ICONS SIZE large
Figure 6.0.1 - Icons Size
CP500
R