TuffStuff TS-1000 Owner's Manual page 19

IG. 64 Route the Tension Cable (#36)
#1) then pull it out through the opening at the top of the
#1). Next, insert two Nylon Pulleys 4 1/2 Rd (#67-Labeled D4, D5) to the
ulley brackets located on the Base Frame (#1) and secure them into
lace using two Hex Head Cap Screws 3/8-16 x 1 3/4 (#102), four Flat
Washers SAE 3/8" (#87), and two Nylon Insert Jam Lock Nuts 3/8-16
#93). Be sure the cable is routed properly into the grooves of the Nylon
Pulleys 4 1/2 Rd. (#67-Labeled D4, D5), as shown above.
Note: Refer to the Cable Mapping Diagram on page 27 for further
detailed illustration of the
NOTE:
IG. 66 Next, using a rubber mallet, insert a Plastic Insert Cap 1 X 2
#73) into the tube-end of the Adjustable Seat Frame
he Seat Pad (#40) and attach it to the
hown above, using two Hex Head Cap Screws 3/8-16 X 1 3/4 (#102),
nd two Flat Washers SAE 3/8" (#87).
TS-1000 Home Gym w/Adjustable High-Low Pulley System
into the tube of Base Frame
Base Frame
Tension Cable (#36) routing.
(#37). Next, locate
Adjustable Seat Frame
FIG. 65
ing a Regular Hex Nut 1/2-13 (#90) and inserting a Split Washer B/O
1/2" (#82) to the Hex Tap Bolt 1/2-13 x 3 (#84). Then, thread the Hex Ta
Bolt 1/2-13 x 3 (#84) to the threaded socket located on the
ble Pulley Bracket
Loosely Fasten: Do not completely fasten this hardware assem
bly at this time, as it will be completely fastened later in the as
sembly process.
LOOSELY FASTEN
Note: Refer to the Cable Mapping Diagram on page 27 for furthe
detailed illustration of the
NOTE:
FIG. 66
Leg Extension Bench Frame
(#37), as sure to release the Turn/Pull Pin w/Knob (#557) as you begin inserting th
assembled
Frame (#9).
Owner's Manual: Assembly Instructions
Conclude the routing of the Tension Cable (#36)
(#32).
Tension Cable (#36)
Insert the assembled Adjustable Seat Frame (#37)
(#9), in the position as shown above. B
Adjustable Seat Frame (#37)
by Thread
Floating Dou
routing.
into th
into the Leg Extension Benc
18