TuffStuff TS-1000 Owner's Manual page 6

IG. 12 Attach the Leg Extension Bench Frame (#9)
rame (#1) and secure it into place using one Hex Head Cap Screw 3/8-
6 X 4 1/2 (#96), two Flat Washers SAE 3/8" (#87), and one Nylon Insert
am Lock Nut 3/8-16 (#93).
rame (#9) to the Front Upright (#6)
Hex Head Cap Screw 3/8-16 X 2 3/4 (#100), two Flat Washers SAE
/8" (87), and one Nylon Insert Jam Lock Nut 3/8-16 (#93).
Loosely Fasten: Do not completely fasten this hardware
assembly at this time, as it will be completely fastened later in the
assembly process.
OSELY FASTEN
Next, using a rubber mallet, insert one Plastic Insert Cap 2" Sq. (#71) into
he front of the Leg Extension Bench Frame (#9).
IG. 14 Using a rubber mallet, insert a Plastic Insert Cap 2" Sq. (#71)
nto the tube-end of the High-Low Selectorized Upright
ert a Nylon Pulley 4-1/2 Rd. (#67-Labeled C#) into the pulley bracket of
he High-Low Selectorized Upright (#13)
ne Hex Head Cap Screw 3/8-16 x 1 3/4 (#102), two Flat Washers SAE
/8" (#87), and one Nylon Insert Jam Lock Nut 3/8-16 (#93)
5
to the
Next, attach the Leg Extension Bench
and secure it into place using one
(#13). Next, in-
and secure it into place using
Base FIG. 13 Locate the
let, insert one Plastic Insert Cap 1 1/2 Sq. (#72) into the tube-end.
Affix the
above, to the Leg Extension Bench Frame (#9)
by inserting the
Extension Bench Frame (#9)
comes flush with both sides of the
Next, secure the
Leg Extension Bench Frame (#9)
(#52), as shown above.
fastening these Set Screws.
FIG. 15 Insert the two Nylon Pulleys 3 1/2 Rd. (#68) into the
Double Pulley Bracket (#15)
Head Cap Screws 3/8-16 x 1 3/4 (#102), four Flat Washers SA
3/8" (#87), and two Nylon Insert Jam Lock Nuts 3/8-16 (#93). Next, as
semble two Hex Head Cap Screws 1/4-20 x 1 1/2 (#104), and two Nylo
Insert Lock Nuts 1/4-20 (#95) to the
(#15), in the positions indicated by the black arrows.
TS-1000 Home Gym w/Adjustable High-Low Pulley System
Leg Extension Arm (#10), and using a rubber ma
Leg Extension Arm (#10), in the position as show
Leg Extension Axle 1/2 X 2-3/4 (#11)
and Leg Extension Arm (#10)
Leg Extension Bench Frame (#9).
Leg Extension Axle 1/2 X 2-3/4 (#11)
using two Set Screws 1/4-20 X 3/
Use the supplied Hex Key 1/8" (#115) fo
and secure them into place using two He
High-Low Double Pulley Bracke
and secure it into plac
through the Le
until it be
to th
High-Low