TuffStuff TS-1000 Owner's Manual page 7

IG. 16 Slide the High-Low Carriage (#14) onto the
orized Upright (#13), in the position as shown above. Be sure to release
he Push Pull Pin 1/2 x 3 1/2 (#56) to allow the insertion of carriage as-
embly.
IG. 18 Caution: It is recommended to use another person in
assisting with this assembly.
CAUTION
Mount the Top Pulley Assembly (#12)
to the Rear Upright (#5) and the
sing two Hex Head Cap Screws 3/8-16 x 4 1/4 (#97), four Flat Washers
SAE 3/8" (#87), and two Nylon Insert Lock Nuts 3/8-16 (92).
Loosely Fasten: Do not completely fasten this hardware assem-
bly at this time, as it will be completely fastened later in the as-
sembly process.
OSELY FASTEN
TS-1000 Home Gym w/Adjustable High-Low Pulley System
High-Low Selec-
to the Front Upright (6), and affix
High-Low Selectorized Upright (#13)
Owner's Manual: Assembly Instructions
FIG. 17 Next, insert the High-Low Sectorized Upright (#13)
tube-connector of the Rear Upright (#5)
one Hex Head Cap Screw 3/8-16 x 2 1/2 (#101), two Flat Washers SAE
3/8" (#87), and one Nylon Insert Jam Lock Nut 3/8-16 (#93).
FIG. 19 Affix the Top Pulley Assembly (#12)
using two Hex Head Cap Screws 3/8-16 x 4 1/4 (#97), four Flat Washer
SAE 3/8" (#87), and two Nylon Insert Lock Nuts 3/8-16 (#92).
onto th
and secure it into place usin
to the Front Upright (#6
6