TuffStuff TS-1000 Owner's Manual page 10

IG. 28 Slide the Top Plate/Selector Bar (#20)
#16) allowing it to come to rest on the completed weight stack.
Note: Be sure the Label located on the
(#20) is facing toward you before you slide the
NOTE:
Bar (#20) over the Guide Rods 3/4 X 72 (#16).
IG. 30 Next, locate the Selector Pin w/Coil (#21)
ver the Selector Bar (#20) as shown above.
9
Label
over the Guide Rods
Top Plate/Selector Bar
Top Plate/Selector
and slide its ring
15
20
25
30
35
45
55
65
75
85
95
105
115
125
140
155
170
185
200
FIG. 29 Attach the Decal Weight Numbers (#113) to the Weight Plate
(#17, #18, #19) in the corresponding order. Begin with the 15 at the top
20 next, and so on.
FIG. 31 Maneuver the two
on the bottom side of the
mount the Guide Rod Retainer Housing (#22)
Guide Rods 3/4 X 72 (#16)
(#12). Secure this assembly using two Hex Head Cap Screws 3/8-16 X
(#112), four Flat Washers SAE 3/8" (#87), and two Nylon Insert Lock Nut
3/8-16 (#92).
Loosely Fasten: Do not completely fasten this hardwar
assembly at this time, as it will be completely fastened later in th
assembly process.
LOOSELY FASTEN
TS-1000 Home Gym w/Adjustable High-Low Pulley System
Guide Rods 3/4 X 72 (#16)
Guide Rod Retainer Housing
along with the two captiv
to the side of the Top Pulley Assembl
into the hole
(#22). Nex