TuffStuff TS-1000 Owner's Manual page 15

IG. 48 Continue to route the
p and over the Nylon Pulley 4 1/2 Rd. (#67-Labeled B3), then down into
he Front Upright's (#6) tube. Next, pull the
Cable (#34) through the opening at the bottom of the
Note: Refer to the Cable Mapping Diagram on page 25 for further detailed
lustration of the Leg Extension/Abdominal Cable
IG. 50 Route the Leg Extension/Abdominal Cable (#34)
eg Extension Arm (#10). Then, affix a Nylon Ball 1 3/4 x 5/16 (#108),
nd a Strap Bracket #20 (#107) to the cable end. Lock them into place
sing a Shoulder Bolt 3/8 x 3/4 (#106), and a Nylon Insert Lock Nut 5/16-
8 (#94).
Next, secure the Leg Extension/Abdominal Cable (#34)
eg Extension Arm (#10) using one Hex Head Cap Screw 1/4-20 (#104),
nd one Nylon Insert Lock Nut 1/4-20 (#95). Refer to Fig. C on page 25
or further illustration of this hardware assembly.
Note: Refer to the Cable Mapping Diagram on page 25 for further
detailed illustration of the
NOTE:
routing.
TS-1000 Home Gym w/Adjustable High-Low Pulley System
Leg Extension/Abdominal Cable (#34)
Leg Extension/Abdominal
Front Upright (#6).
(#34)routing.
Leg Extension/Abdominal Cable (#34)
FIG. 49 Insert two Nylon Pulleys 4 1/2 Rd. (#67-Labeled B4), one to th
bottom pulley bracket of the
bracket of the
two Hex Head Cap Screws 3/8-16 x 1 3/4 (#102), four Flat Washers SAE
3/8" (#87), and two Nylon Insert Jam Lock Nuts 3/8-16 (#93).
up to the FIG. 51 Press down the
apply tension to the
attach the
using the previously removed Hardware (one Hex Head Cap Screw 3/8-1
x 2 3/4 (#100), two Flat Washers SAE 3/8" (#87), and one Nylon Inse
to the Jam Lock Nut 3/8-16 (#93).
Owner's Manual: Assembly Instructions
Front Upright (#6)
Leg Extension Arm (#10). Secure them into place usin
Closed-End Double Pulley Bracket (#31)
Leg Extension/Abdominal Cable
Leg Extension Bench Frame (#9)
and the other to the pulle
t
(#34). Then, re
to the Front Upright (#6
14