Table of Contents
Advertisement
IG. 60
Next, route the
High-Low Cable (#35)
age (#14)
and insert the cable to the welded bracket on the side of the
High-Low Carriage
(#14), as shown in caption above. Lock the
ow Cable (#35)
into place using one Shoulder Bolt 3/8 x 3/4 (#106), and
ne Nylon Insert Lock Nut 5/16-18 (#94).
Note: Refer to the Cable Mapping Diagram on page 26 for further
detailed illustration of the
NOTE:
IG. 62
Route the
Tension Cable (#36)
Double Pulley Bracket (#30)
abeled D1), as shown above.
Note: Refer to the Cable Mapping Diagram on page 27 for further
detailed illustration of the
NOTE:
17
up to the
High-Low Car-
High-Low Cable (#35)
routing.
up to the
Closed-End Adj.
and over the Nylon Pulley 4 1/2 Rd (#67-
Tension Cable (#36)
routing.
FIG. 61
Affix the looped end of the
bracket located on the
High-
3/8-16 x 1 3/4 (#102), two Flat Washers SAE 3/8" (#87), two Nylon spac
ers 3/8 x 3/8 (#109), and one Nylon Insert Jam Lock Nut 3/8-16 (#93).
Note: Refer to Fig F on page 27 for further illustration of this as
sembly.
NOTE:
FIG. 63
Continue routing the
Nylon Pulley 4 1/2 Rd (#67-Labeled D2). Then, up and over the Nylo
Pulley 4 1/2 Rd (#67-Labeled D3).
Note: Refer to the Cable Mapping Diagram on page 27 for furthe
detailed illustration of the
NOTE:
TS-1000 Home Gym w/Adjustable High-Low Pulley System
Tension Cable (#36)
Base Frame (#1)
using one Hex Head Cap Screw
Tension Cable (#36)
Tension Cable (#36)
to the pulle
down and under th
routing.
Hide quick links:
Advertisement
Table of Contents
