TuffStuff TS-1000 Owner's Manual page 11

IG. 32 First, locate the Adjustable Pulley Bracket (#27)
ne Nylon Pulley 4 1/2 Rd. (#67-Labeled A8). Secure the Nylon Pulley 4
/2 Rd. (#67-Labeled A8) into place using one Hex Head Cap Screws 3/8-
6 X 1 3/4 (#102), two Flat Washers SAE 3/8" (#87), and one Nylon Insert
am Lock Nut 3/8-16 (#93). Next, thread one Regular Hex Nut 1/2-13
#90), and insert one Split Washer B/O 1/2" (#82) over the bolt on the
Adjustable Pulley Bracket (#27), as shown above. Second, locate the
wo Adjustable Stoppers (#28, #29)
/2-13 (#90), and insert one Split Washer B/O 1/2" (#82) over each bolt,
s shown above.
IG. 34 Insert the welded bolt of the
hrough the hole located on the
nto place at the top using one Flat Washer SAE 1/2" (#86), and one Nylon
nsert Lock Nut 1/2-13 (#91).
Loosely Fasten: Do not completely fasten this hardware assem-
bly at this time, as it will be completely fastened later in the as-
sembly process.
OSELY FASTEN
TS-1000 Home Gym w/Adjustable High-Low Pulley System
and thread one Regular Hex Nut
Adjustable Pulley Bracket (#27)
Top Pulley Assembly (#12) and secure it
and insert FIG. 33 Locate the
the Closed-End Double Pulley Bracket (#31).
Pulleys 4 1/2 Rd. (#67-Labeled D3,B2,D1,A7). Secure them into plac
using four Hex Head Cap Screws 3/8-16 X 1 3/4 (#102), eight Fla
Washers SAE 3/8" (#87), and four Nylon Insert Jam Lock Nuts 3/8-1
(#93).
Note: The four holes on the
Bracket (#30)
NOTE:
routing has been completed.
Next, locate the
the right, and attach two Nylon Pulleys 4 1/2 Rd. (#67-Labeled C7,C5)
Secure the pulleys into place using one Hex Head Cap Screw 3/8-16 X
3/4 (#100), two Flat Washers SAE 3/8" (#87) and one Nylon Insert Jam
Lock Nut 3/8-16 (#93).
FIG. 35
(#28) into the receptacle of the
using one Split Washer B.O. 1/2" (#82), and one Regular Hex Nut 1/2-1
(#90), as shown above.
(#84) to allow adjustment for cables tension later in the assembly process
Owner's Manual: Assembly Instructions
Closed-End Adj. Double Pulley Bracket
Closed-End Adj. Double Pulle
are used to adjust the cable tension once the cabl
Floating Double Pulley Bracket
Insert (from bottom to top) the
Front Upright (#6)
Loosely fasten the Regular Hex Nuts 1/2-1
(#30), an
Then, attach four Nylo
(#32), shown above a
Long Adjustable Stoppe
and secure it into plac
10