TuffStuff TS-1000 Owner's Manual page 9

IG. 24 Next, secure the Press Bar Selector Housing (#23)
Pivot Axle 1 X 8 1/8 (#24) using two Set Screws 3/8-16 X 1/2 (#51), as
hown above. Then, secure into place the
Axle 1 X 8 1/8 (#24) using two Set Screws 3/8-16 X 1/2 (#51). Use the
Supplied Hex Key 3/16 (#114) for securing the Set Screws 3/8-16 X 1/2
#51) into the threaded sockets on the
#23).
IG. 26 Insert one Rubber Donut 3/4 x 2 1/2 (#64) onto each
Rod 3/4 x 72 (#16). Next, insert the two
he receptacles on the Base Frame
TS-1000 Home Gym w/Adjustable High-Low Pulley System
Press Bar (#25) to the
Press Bar Selector Housing
Guide Rods 3/4 x 72 (#16)
(#1), as shown above.
to the FIG. 25 Next, attach two Nylon Pulleys 4 1/2 Rd. (#67-Labeled A3, A5
to the pulley bracket located on the
Pivot and secure them into place using one Hex Head Cap Screw 3/8-16 X
3/4 (#100), two Flat Washers SAE 3/8" (#87), and one Nylon Insert Jam
Lock Nut 3/8-16 (#93).
Guide FIG. 27 Carefully begin sliding the
into Rods (#16) beginning with the five
tom, the nine 10 Lb. Weight Plates (#18)
Weight Plates (#19)
Owner's Manual: Assembly Instructions
Press Bar Selector Housing (#25
Weight Plates
15 Lb. Weight Plates (#17)
in the middle, and the five
on top of the weight stack.
over the Guid
at the bo
5 Lb
8