TuffStuff TS-1000 Owner's Manual page 17

IG. 56 Next, locate the Floating Double Pulley Bracket (#32)
ontinue to route the High-Low Cable (#35)
Pulley 4 1/2 Rd. (#67-Labeled C5). Then, up and over the Nylon Pulley 4
/2" Rd. (#67-Labeled C6).
Note: Refer to the Cable Mapping Diagram on page 26 for further
detailed illustration of the
NOTE:
IG. 58 Next, route the High-Low Cable (#35)
he Rear Upright (#5). Next, insert a Nylon Pulley 4 1/2 Rd. (#67-Labeled
C8) into the slot of the Rear Upright (#5)
ne Hex Head Cap Screw 3/8-16 X 2 1/2 (#101), two Flat Washers SAE
/8" (#87), and one Nylon Insert Jam Lock Nut 3/8-16 (#93). Be sure the
able is routed properly into the groove on the Nylon Pulley 4 1/2 Rd.
#67-Labeled C8).
Note: Refer to the Cable Mapping Diagram on page 26 for further
detailed illustration of the
NOTE:
TS-1000 Home Gym w/Adjustable High-Low Pulley System
down and under the Nylon
High-Low Cable (#35) routing.
down into the tube of
and secure it into place using
High-Low Cable (#35) routing.
and FIG. 57 Next, route the
lon Pulley 4 1/2 Rd. (#67-Labeled C7).
Note: Refer to the Cable Mapping Diagram on page 26 for furthe
detailed illustration of the
NOTE:
FIG. 59 Continue routing the
of the Rear Upright
the bottom of the
Nylon Pulley 4 1/2 Rd. (#67-Labeled C9), as shown above. Secure th
Nylon Pulley 4 1/2 Rd. (#67-Labeled C9) to the
one Hex Head Cap Screw 3/8-16 X 2 1/2 (#101), two Flat Washers SAE
3/8" (#87), and one Nylon Insert Jam Lock Nut 3/8-16 (#93). Be sure th
cable is routed properly into the groove on the Nylon Pulley 4 1/2 Rd
(#67-Labeled C9).
Note: Refer to the Cable Mapping Diagram on page 26 for furthe
detailed illustration of the
NOTE:
Owner's Manual: Assembly Instructions
High-Low Cable (#35)
High-Low Cable (#35)
High-Low Cable (#35)
(#5). Next, pull the Cable end through the opening a
Rear Upright (#5). Then, route the cable around
Rear Upright (#5)
High-Low Cable (#35)
down and under the Ny
routing.
down into the tub
usin
routing.
16