Kvm Panel; Removing The Kvm Panel - Dell PowerEdge FX2 Owner's Manual

Steps
1. Connect the control panel cable to the control panel.
2. Press the ZIF connector release latch into place.
3. Install the screw to secure the control panel cover to the control panel.
4. Align the screw holes on the control panel with the screw holes on the side of the system.
5. Install the two screws to secure the control panel to the side of the system.
6. Insert the control panel cable in the cable tube.
7. Align the screw holes on the cable tube with the screw holes on the side of the system.
8. Install the three screws to secure the cable tube to the side of the system.
Next steps
Follow the procedure listed in

KVM panel

Removing the KVM panel

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: This is a field replaceable unit (FRU). Removal and installation procedures must be performed
only by Dell certified service technicians.
NOTE: You must remove the KVM panel to replace a faulty panel.
1. Ensure that you read the
2. Follow the procedure listed in
Steps
1. Remove the three screws that secure the cable tube to the side of the system and remove the cable
tube.
2. Remove the two screws that secure the KVM panel to the system.
After working inside your
Safety instructions.
Before working inside your
system.
system.
83