I/O Module; Removing An I/O Module - Dell PowerEdge FX2 Owner's Manual

Figure 38. Removing and installing a CMC module SD card
1. SD card
Next steps
Install the CMC module and reattach any cables that were disconnected.
The SD card is activated automatically.
Related Tasks
Removing the CMC module
Installing the CMC module

I/O module

Your system supports up to two hot-swappable I/O modules that provide external network connectivity.

Removing an I/O module

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: You must remove an I/O module to replace a faulty module or service other components of
the system.
NOTE: An I/O module is hot-swappable.
Ensure that you read the
Steps
1. Disconnect the cables attached to the I/O module.
2. Press the release latch and slide the I/O module out of the enclosure.
48
Safety instructions.
2. SD card connector