Installing The Control Panel - Dell PowerEdge FX2 Owner's Manual

3. cable tube
3. Remove the screw that secures the control panel cover to the control panel.
4. Release the ZIF connector latch.
5. Using the pull-tab, remove the control panel cable from the control panel.
NOTE: To prevent damage to the control panel cable, exercise utmost care when removing the
control panel cable from the control panel.
6. Remove the control panel from the system.
Figure 63. Removing and installing the control panel
1. ZIF connector latch
3. control panel cover
Next steps
Install the control panel.
Related Tasks

Installing the control panel

Installing the control panel
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: This is a field replaceable unit (FRU). Removal and installation procedures must be performed
only by Dell certified service technicians.
1. Ensure that you read the
2. Follow the procedure listed in
3. Remove the control panel.
NOTE: You must remove the control panel to replace a faulty control panel.
82
Safety instructions.
Before working inside your
4. control panel cable
2. connector
4. screw
system.