Power Interposer Board - Dell PowerEdge FX2 Owner's Manual

Related Tasks
Installing the top interposer module
Installing the bottom interposer module
Installing the fan interface board
Installing the PCIe switch board
Installing a PCIe module
Installing the cooling-fan cage
Installing a cooling fan
Installing the system cover
Installing an I/O module
Installing the CMC module
Installing a power supply unit
Installing a storage sled
Installing a compute sled

Power interposer board

Removing the power interposer board
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: This is a field replaceable unit (FRU). Removal and installation procedures should be
performed only by Dell certified service technicians.
1. Ensure that you read the
2. Follow the procedure listed in
3. Remove the midplane assembly.
Steps
1. Remove the Mylar insulator.
2. Disconnect the power bus bar and the cable cover from the midplane assembly.
3. Disconnect the power bus bar and the cable cover from the power interposer board.
4. Remove the four screws that secure the power interposer board to the carrier.
5. Lift the power interposer board from the carrier.
Safety instructions.
Before working inside your system.
79