Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Dell Inc. disclaims any proprietary interest in trademarks and trade names other than its own.
Installation and Configuration WARNING: Before performing the following procedure, review the safety instructions that came with all Storage Center components. Unpacking the System NOTE: Unpacking, installing, and deploying your Storage Center may be done only by a certified service technician. Before you begin, make sure the site where you intend to set up and use the Storage Center has the following: •...
Page 4
Always load the rack from the bottom up for weight stability. • You can allow room for expansion if you have fewer than the • maximum number of enclosures. 8 Unwrap and insert each drive into the enclosure one at a time. Protect the drive from static discharge.
Page 5
Connecting the Power Cables 1 Ensure that the power switch is in the OFF position before connecting the power cables. 2 Connect the enclosure power cables to the rack power. Securing the Power Cables 1 Bend the power cables as shown in the illustration and secure the cables firmly to the bracket using the strap provided.
Page 6
2 Plug the other end of the power cables into a grounded electrical outlet or a separate power source such as an uninterrupted power supply (UPS) or a power distribution unit (PDU). Location of Power Button NOTE: Do not power up the enclosure until all Storage Center components are racked and cabled.
Other Information You May Need WARNING: See the safety and regulatory information that shipped with your Storage Center components. Warranty information may be included within this document or as a separate document. • The rack documentation included with your rack solution describes how to install your system into a rack.
The following information is provided on the device described in this document in compliance with the requirements of the official Mexican standards (NOM): Importer: Dell Inc. de México, S.A. de C.V Paseo de la Reforma 2620-11 ° Piso Col. Lomas Atlas 11950 México, D.F.
Page 9
Management RAID management using Storage Center System Manager version 6.2 or later Back-Plane Board Connectors • SC200: 12 SAS hard-drive connectors • SC220: 24 SAS hard-drive connectors • Two power supply/cooling fan module connectors • Two sets of EMM connectors •...
Page 10
10 ms or less Available Hard Drive Power (Per Slot) Supported hard drive power SC200: Up to 1.16 A at +5 V, consumption (continuous) Up to 1.6 A at +12 V SC220: Up to 1.2 A at +5 V, Up to 0.5 A at +12 V...
Page 11
Physical (continued) Weight (maximum configuration) SC200: 29.2 kg (64 lb) SC220: 24 kg (53 lb) Weight (empty) SC200: 8.84 kg (19.5 lb) SC220: 8.61 kg (19 lb) Environmental NOTE: For additional information about environmental measurements for specific system configurations, see dell.com/environmental_datasheets.
Page 12
Environmental (continued) Storage • Half-sine shock 71G +/- 5% with a pulse duration of 2ms +/- 10% (all sides) • Square wave shock 27G with a velocity change of 235 in/sec (all sides) Altitude Operating –16 to 3048 m (–50 to 10,000 ft) NOTE: For altitudes above 2950 feet, the maximum operating temperature is...
Page 14
w w w. d e l l . c o m | s u p p o r t . d e ll . c o m...
Need help?
Do you have a question about the SC200 and is the answer not in the manual?
Questions and answers